SANTIMPEX - Deva - Echipamente ATI » CETUS x15 Critical Care Patient Monitor

Detalii

Detalii produsFeatures• 15.6” High resolution TFT LCD Touch screen• 10 waveform display, up to 12-lead ECG analysis• Powerful calculation (Hemodynamic, Drug Dose, Oxygenation, Ventilation)• Pacemaker detection• ST & arrhythmia analysis• SpO2 support PVI and PI, low perfusion 0.2%• Aspect BISx module, NMT (Organon TOF-Watch®) module optional• Wired/Wireless CMS, support HL7 protocol to HIS• SpO2 pulse-tone modulation (Pitch Tone)• VGA support external display• Graphical & tabular trend review (120 hours)• 48 hours full disclosure wave review for each patient (stored in SD card) Configuration5-lead ECG, SpO2, NIBP, TEMP, Resp, PR; Li-ion battery OptionalTouch-Screen, 12-lead ECG, Masimo/Nellcor SpO2, IBP, C.O., EtCO2, Multi-Gas, BIS, NMT, VGA, Thermal Recorder, Wired/Wireless CMS TEHNICAL SPECIFICATIONS Display15.6” TFT (touch screen optional)Resolution: 1366 x 768Number of traces: 12 waveforms I/OLAN: 1 standard RJ45 portWLAN: IEEE 802.11b/g/nUSB: 2 USB connectorsSD: 1 SD card socketVGA: 1 VGA monitor connectorOutput: 1 connector for Nurse call, Defib Sync Analog Output ECGLead type: 3-lead, 5-lead,12-leadECG waveform: 2 channels, 7 channels, 12 channelsDisplay sensitivity: 2.5 mm/mV (×0.25), 5 mm/mV (×0.5), 10 mm/mV (×1.0), 20 mm/mV (×2.0)Wave sweep speed: 6.25 mm/s, 12.5 mm/s, 25 mm/s, 50 mm/sBandwidthDiagnostic mode: 0.05 Hz~100 HzMonitor mode: 0.5 Hz~40 HzSurgery mode: 1 Hz~20 HzStrong filter mode: 5Hz~20 HzCMRR>100 dBNotch: 50/60 Hz notch filter can be set to on or offDifferential input impedance >5MΩElectrode polarization voltage range: ±400mVBaseline recovery time <3s after defibrillation (in monitor and surgery mode)Calibration signal: 1 mV (peak - peak), accuracy ±3% RESPMeasurement method: Thoracic electrical bioimpedanceMeasuring lead: Lead I, IIWave gain: ×0.25, ×0.5, ×1, ×2Respiratory impedance range: 0.5-5 ΩBaseline impedance: 500-4000 ΩGain: 10 gradesScan speed: 6.25 mm/s, 12.5 mm/s, 25 mm/s TEMPAccuracy: ±0.1 or ±0.2 °F (without probe)Measurement range: 5~50? (41~122 °F)Channel: Two channelsResolution: 0.1?Parameters:?T1, T2 and TD SpO2Measurement range: 0-100%Resolution: 1%Accuracy: ±2% (70-100%, Adult/Pediatric); ±3% (70-100%, Neonate); 0-69%, unspecifiedRefreshing Rate: 1s Masimo SET® SpO2(Optional)Measurement range: 0-100%Resolution: 1%Accuracy: ±2% (70-100%, Adult/Pediatric, non-motion, low prefusion); ±3% (70-100%, Neonate, non-motion); ±3% (70-100%, motion); 0-69%, unspecifiedRefreshing Rate: 1s Pulse RateRange: 30~300 bpmResolution: 1 bpmAccuracy: ±2bpm (non-motion); ±5bpm (motion)Refreshing rate: 1s NIBPMeasurement method: Automatic oscillometric methodOperating mode: Manual, automatic, continuousMeasurement unit: mmHg/kPa selectableTypical measurement time: 20~40 sMeasurement type: Systolic, Diastolic,Mean Measurement range (mmHg)Range of Systolic pressure:Adult 40-270Pediatric 40-200Neonatal 40-135Range of Diastolic pressure:Adult 10-210Pediatric 10-150Neonatal 10-95Range of Mean pressure:Adult 20-230Pediatric 20-165Neonatal 20-105Measurement accuracyMaximum average error: ±5 mmHgMaximum standard deviation: 8 mmHgResolution: 1 mmHgInterval: 1, 2, 3, 4, 5, 10, 15, 30, 60, 90, 120, 180, 240, 480 minutesOverpressure protection: Software and hardware, double safety protectionCuff pressure range: 0-280 mmHg IBP (Optional)Channel: 2-channel or 4-channelART: 0 to 300 mmHgPA: -6 to 120 mmHgCVP/RAP/LAP/ICP: -10 to 40 mmHgMeasurement range: P1/P2 -50 to 300 mmHgResolution: 1mmHgAccuracy: ±2% or ±1mmHg, whichever is greater (without sensor)Sensitivity: 5uV/mmHg/VImpedance range: 300 to 3000 Ω C.O. (Optional)Method: ThermodilutionRange: C.O.: 0.2 to 20 L/minTB: 23 to 45 ?T1: -1 to 27?Accuracy: C.O.: ±5% or ±0.1L/min, whichever is greater TB, T1?±0.5? (without sensor) Standard Mainstream CO2 (Optional)Measurement range: 0-19.7%, 150 mmHg, or 0-20 kPaResolution: 0.1 mmHgMeasurement accuracy:0-40 mmHg: ± 2 mmHg41-70 mmHg: ± 5% of reading71-100 mmHg: ± 8% of reading101-150 mmHg: ± 10% of readingRespiration rate: 3-150 bpmRespiration rate accuracy: 1 ±1bpmWarm-up time: 97% within 8 s, full accuracy within 20 s Standard Sidestream CO2 (Optional)Measurement rage: 0-20% (0-150 mmHg)Accuracy:< 5.0% CO 2: ± 2 mmHg> 5.0% CO 2: < 6% of readingRespiration rate: 2~150 BPMRespiration rate accuracy: 1% ±1BPMWarm-up time: 97% within 45 s, full accuracy within 10 min.Rise times (t 10-90%): About 100 ms, when flow is 100 ml/min, adult water trap, 1.5 m sampling tubeDelay time: <3 sec when flow is 100 ml/min, adult water trap, 1.5 m sampling tube Recorder (Optional)Built-in, Thermal dot arrayHorizontal resolution: 16 dots/mm (25 mm/s paper speed)Vertical resolution: 8 dots/mmPaper speed: 25 mm/s, 50 mm/sNumber of waveform channels: 3 Phasein ISA Sidestream CO2 (Optional)Warm-up time: Full accuracy within 10 secondsSampling flow rate: 50ml/min(+/-10/min)Measurement Range: 0-25%Accuracy:0~15% (±0.2% of the reading)15~25%, unspecifiedRise time: 200 ms, typical at 50 ml/min flow rateTotal response time: within 3 seconds (with 2 m Momoline sampling line)AWRR Range: 0-150 bpmAWRR Accuracy: ±1 breath Phasein IRMA™ Mainstream CO2 (Optional)Measurement Range: 0-25%Accuracy:0~15% (±0.2% of the reading)15~25%, unspecifiedWarm-up time: Full accuracy within ‚ 10 secondsAWRR Range: 0-150 bpmAWRR Accuracy: ±1 breath Phasein IRMA™ AX+ Mainstream Multi-gas (Optional)Gas: CO2, N2O, HAL, ISO, ENF, SEV, DES with automatic identificationWarm-up time: Full accuracy within 20 seconds for IRMAAX+ CO2 Accuracy:0-10%: ± (0.2%+2% of the reading)0-15%: ± (0.3%+2% of the reading)N2O Accuracy:0-100%: ± (2%+2% of the reading)HAL, ISO, ENF:0-8%: ± (0.15%+5% of the reading)SEV:0-10%: ± (0.15%+5% of the reading)DES:0-22%: ± (0.15%+5% of the reading)Agent identification time: <20 s (typical <10 s)AWRR range: 0-150 bpmAWRR accuracy: +/-1bpmApnea time: 20~60 s Aspect BISx module (Optional)Parameter Measurement:BC: 0~30 (Only limited to the combined use of an external sensor with a BIS module)EMG: 30~55 dB (bar chart) with intensity between 30 dB and 80 dB (tendency chart)BIS: 0~100SQI: 0%~100%SR: 0%~100%SEF: 0.5 Hz~30 HzTP: 40~100 DbEEG Measurement:Input impedance >5 MΩNoise (RTI) <2 μV (0.25~50 Hz)Input signal range: ±1 MvEEG bandwidth between: 0.25 Hz~110 Hz NMT Tof-Watch® SX (Optional)Microprocessor-controlledStimulation Mode: TOF, TOFS, PTC,1 Hz Twitch, 0.1 Hz Twitch, DBS DBS3.3 and3.2 (Double Burst), Tetanic Stimulation (Burst),5s – 50 Hz or 100 HzOutput (accuracy ±5% of full scale value)Surface electrodes:Constant current, 0-60 mA (0-12/18μC) up to 5 KOhm.Monophasic, 200 μs or 300 μs pulse widthNeedle electrodes:Constant current,0-6 mA (0-0.24 μC) up to 5 KOhm.Monophasic, 40 μs pulse widthAcceleration transducer: Accuracy ±5% of full scale valueTemperature sensor: Range 20.0-41.5°C (accuracy ±5 °C) Operation EnvironmentPower: AC 100-250 V, 50/60 HzTemperature: 5-40 °CHumidity: <80%Patient Range: Adult, Pediatric, Neonate  Va rugam sa ne contactati pentru oferta de pret!Echipa SANTIMPEX  <a href="http://www.santimpex.ro/ati/cetus-x15-critical-care-patient-monitor">http://www.santimpex.ro/ati/cetus-x15-critical-care-patient-monitor</a>